Hello! We have PrintrBoard Rev.E and frimware Marlin (We using in PrintrBoard Rev D.), and have problem:
When we pluging in any of motors (Nema 17, 17HS4417) to extruder ( on the X and Y axes they work properly) and try to start extruding, motor starts to make noise and after he finished working ( approximately after 10 sec.) inside of the motor appear pulsating sounds.
Maybe Need change settings in Extruder? If needed, so what?
When we pluging in any of motors (Nema 17, 17HS4417) to extruder ( on the X and Y axes they work properly) and try to start extruding, motor starts to make noise and after he finished working ( approximately after 10 sec.) inside of the motor appear pulsating sounds.
Maybe Need change settings in Extruder? If needed, so what?
